Gains

The Room Type Manager Gains panel contains controls used to define heat gains resulting from heat sources in rooms of the selected room type.

Note: Gains data on subsequently created rooms of the selected room type can be edited individually using the corresponding gains controls found on the Properties For: Room dialog box or globally using the controls found on the Global Changes dialog box’s Gains (Steady State) panel.

Tip: Additional gains can be added to rooms using the controls found on the Properties for: Gains dialog box. This dialog box is accessed by highlighting the selected room’s Gains component from the project tree dialog box, and selecting Properties from its pop-up menu.

Setting	Description
Gain type	Used to select the type of equipment the gain component is being defined for. The available types are listed below. Electric Gas Hot water Steam Other
New	Used to create new gain sub-components, each defined independently using the controls and setting listed below. (New) gain — Whenever the New button is pressed, and new gain sub-component panel is created. The controls provided for it can be set independent of the other gain sub-components in the Properties For: Gains dialog box. Delete icon — Used to delete the gain sub-component.
Name	Used to enter a name for the gain sub-component.
Design level calculation method	Contains controls used to select the Design level calculation method to be used for calculating the nominal electric equipment level for the room in which the equipment component is located. Equipment level — When selected, the method used will be a straight insertion of the electric equipment level (Watts or BTU’s) for the room. Power per area — When selected, the method used will be a factor of equipment level (Watts) per floor area of the room. Power per person — When selected, the method used will be a factor of equipment level (Watts) per person.
Design level	Used to set the total power level for the Equipment level calculation method.
Watts per Zone Floor Area	Used to set the total power level in terms of unit square footage for the Power per area calculation method.
Watts per Person	Used to set the total power level in terms of persons for the Power per person calculation method.
Fraction latent	Used to set the amount of latent heat given off by the equipment component in the room. Fraction latent is a decimal number between 0.0 and 1.0. This number is multiplied by the total power consumed by the equipment component to give the amount of latent energy produced. This energy affects the moisture balance within the room the equipment component is located.
Fraction radiant	Used to set the amount of long-wave radiant heat being given off by the equipment component in the room. Fraction radiant is a decimal number between 0.0 and 1.0. This number is multiplied by the total power consumed by the equipment component to give the amount of long wave length radiation gain from the equipment component.
Fraction lost	Used to set the amount of lost heat being given off by the equipment component in the room. Fraction lost is a decimal number between 0.0 and 1.0. This number multiplied by the total power consumed by the equipment component to give the amount of heat which is lost and does not impact the room energy balances. This might correspond to electrical energy converted to mechanical work or heat that is vented to the atmosphere.
Schedule	Used to select a schedule describing the equipment operational hours.
End usage category	Used to enter a user-defined end-use subcategory, e.g., "Pumps", "Office Equipment", etc. A new meter for reporting is created for each unique subcategory. Subcategories are also reported in the ABUPS table. If this field is omitted or blank, the equipment component will be assigned to the General end-use subcategory.